The smallrig Base for cages has pads on the superior, these prevent the attached device from suffering damage while this mount is being used. Compatible with a wide variety of cages of the brand of different brands. It has an opening to be able to place a tripod or a similar accessory.
![]()
Add a quick release plate to your camera case smallrig with this Arca-type quick release plate. The lightweight aluminum plate attaches to the bottom of the cage with the two included 1/4"-20 screws and can fit on a standard Ark-like base.
The board has an open-half design so you can access the camera mounting screw through the board. This design allows the plate to remain attached to the cage, and you can easily disassemble the cage chamber to move it to a gimbal, tripod or other supports. The plate features rubber pads to protect the cage and has spring-loaded non-slip pins to prevent them from twisting.
Currently, the board is compatible with the following cages smallrig. Check with the manufacturer for compatibility if you don't see your model below.
Note: This board is not compatible with the motherboard smallrig 2035 or 1934.
Compatibility
NIKON
SONY
Blackmagic Design
Fujifilm
PANASONIC
CANON
Olympus
GoPro
The smallrig Base for cages has pads on the superior, these prevent the attached device from suffering damage while this mount is being used. Compatible with a wide variety of cages of the brand of different brands. It has an opening to be able to place a tripod or a similar accessory.
